SkyLink SA-001S Manuale Utente Scaricare il pdf (Pagina 13)

You can enable or disable the Alert Notication. When it is set to enable, the

Wireless External Alarm will beep when arm or disarm or during the entry/exit

countdown period. When it is set to disable, the Wireless External Alarm will not

beep when arm or disarm or during the entry/exit countdown period. However, the

LED will remain ashing as it is. The Wireless External Alarm will still siren when

it is triggered.

Unplug all the power (batteries and AC adapter) when setup the Alert Notication.

Factory default is set to “Enable”. To select, you will see a jumper connector marked

“J1” as shown below. Use a paper clip to remove the jumper connector and

re-locate to the proper posts. Apply the power to the Wireless External Alarm again

after setup the Alert Notication

A LErT NOTIFIcATION JumPEr

Alert Notication Jumper (J1)

Mode Jumper (J1) Setting

Enable

Set the connector to top 2

posts (1-2)

Disable

Set the connector to bottom 2

posts (2-3)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Nessun commento

SkyLink SA-001S Manuale Utente Pagina 13